Join the

"650 V Stars "Custom, Classic & Dragstar"

Forum
 

Here is a simple way to hide the handlebar wires and clean up that area without splicing. By Dustin

First unplug the  Individual connectors

Then insert a paper clip and pop out the individual wires.

Here is the wire color code for each of the connectors.

Remove the controls from the bar . You can leave the grips and mirror mounts . Just remove the end caps from the grips .

Drill a hole into the bar on each side in a location that will be covered by the controls . Angle this hole as much as possible toward the center of the bike .Also drill a hole in the lower part of the bar (in the bend ) for the wires to enter the bar. Angle these holes toward the bars end . Use the round file to get rid of burs in these holes after drilling . Run the wires through the bar and reinstall the plugs into the connector.